[Solved] console logging showing up in configs during backups

Unimus support forum
Post Reply
jjonesjr
Posts: 29
Joined: Mon Oct 10, 2016 12:27 pm

Mon Mar 18, 2019 7:32 pm

Hi all,

I found an issue with a Cisco SMB SG300. Some times during the backup process there are events that cause console output.. this then looks like part of the config and shows as a config change.

I've attached a screenshot of the email notification.
OUTLOOK_2019-03-18_14-30-04.png
OUTLOOK_2019-03-18_14-30-04.png (21.85 KiB) Viewed 6104 times
This isn't that big of a deal as it doesn't happen often... but I wonder if there's a way to make this stop.

Thanks,

Jim
User avatar
Tomas
Posts: 1206
Joined: Sat Jun 25, 2016 12:33 pm

Mon Mar 18, 2019 9:02 pm

Hi,

Is there no way to turn off logging to console on these switches.

Something like "no terminal monitor" or similar?
jjonesjr
Posts: 29
Joined: Mon Oct 10, 2016 12:27 pm

Tue Mar 19, 2019 6:17 pm

Yep,

Code: Select all

no logging console
That did the trick.

Guess how I am going to deploy that to 60+ switches?! :)

Thanks Tomas!

Jim
User avatar
Tomas
Posts: 1206
Joined: Sat Jun 25, 2016 12:33 pm

Tue Mar 19, 2019 7:05 pm

jjonesjr wrote:
Tue Mar 19, 2019 6:17 pm

Guess how I am going to deploy that to 60+ switches?! :)
I will take a wild guess and say Mass Config Push? :)

Anyway, happy to hear that worked for you, marking the topic as [Solved].
jjonesjr
Posts: 29
Joined: Mon Oct 10, 2016 12:27 pm

Wed Jul 01, 2020 7:12 pm

Hi Tomas... This issue has resurfaced as I've found that the other engineers on the team prefer to leave console logging turned on all the time. Any chance turning off console logging could be baked into the device definition so that during a backup, it is turned off, then back on at the end? I suppose there would need to be some logic to check to see if it is on or off first so that it would not be put into a different state than it was found.

Thanks,

Jim
Post Reply