Page 1 of 1
[Solved] console logging showing up in configs during backups
Posted: Mon Mar 18, 2019 7:32 pm
by jjonesjr
Hi all,
I found an issue with a Cisco SMB SG300. Some times during the backup process there are events that cause console output.. this then looks like part of the config and shows as a config change.
I've attached a screenshot of the email notification.
- OUTLOOK_2019-03-18_14-30-04.png (21.85 KiB) Viewed 6263 times
This isn't that big of a deal as it doesn't happen often... but I wonder if there's a way to make this stop.
Thanks,
Jim
Re: console logging showing up in configs during backups
Posted: Mon Mar 18, 2019 9:02 pm
by Tomas
Hi,
Is there no way to turn off logging to console on these switches.
Something like "no terminal monitor" or similar?
Re: console logging showing up in configs during backups
Posted: Tue Mar 19, 2019 6:17 pm
by jjonesjr
Yep,
That did the trick.
Guess how I am going to deploy that to 60+ switches?!
Thanks Tomas!
Jim
Re: console logging showing up in configs during backups
Posted: Tue Mar 19, 2019 7:05 pm
by Tomas
jjonesjr wrote: ↑Tue Mar 19, 2019 6:17 pm
Guess how I am going to deploy that to 60+ switches?!
I will take a wild guess and say Mass Config Push?
Anyway, happy to hear that worked for you, marking the topic as [Solved].
Re: [Solved] console logging showing up in configs during backups
Posted: Wed Jul 01, 2020 7:12 pm
by jjonesjr
Hi Tomas... This issue has resurfaced as I've found that the other engineers on the team prefer to leave console logging turned on all the time. Any chance turning off console logging could be baked into the device definition so that during a backup, it is turned off, then back on at the end? I suppose there would need to be some logic to check to see if it is on or off first so that it would not be put into a different state than it was found.
Thanks,
Jim