I have a Cisco 2811 with console cables for a Terminal server. For some reason the config changes the baud on the aux port in the config each time Unimus is run. Not sure why--nothing is connected to the AUX port on the router. It's not a problem with Unimus. So, I have created a filter for this using a regex and it doesnt seem to work. I have changed it to "starts with" and that does not work either.
Here is the output from the email. Line 435 is the one that seems to fluctuate for some reason. It's always the same line. I want to include the line in the config, but exclude it from detecting a change.
I have hard coded the AUX port to 19200 and hopefully this will be static in the config and will eliminate the need for an ignored filter. But i'm not sure what i'm doing wrong in the filter. It doesnt seem to apply to the config.
Thank you!
Code: Select all
Vendor: Cisco
Type: IOS router
Downloaded: Sat, 18 Dec 2021, 08:30 AM
Vendor: Cisco
Type: IOS router
Downloaded: Sat, 18 Dec 2021, 11:00 AM
...(424 lines hidden)
425 425
426 426 ^C
427 427 !
428 428 line con 0
429 429 password 7 *************************
430 430 line aux 0
431 431 modem InOut
432 432 modem autoconfigure discovery
433 433 transport input all
434 434 stopbits 1
435 - speed 1200
435 + speed 300
436 436 flowcontrol hardware
437 437 line 0/0/0
438 438 session-timeout 20
439 439 location cable0-0-0
440 440 rotary 1
441 441 no exec
442 442 transport input telnet ssh
443 443 transport output none
444 444 stopbits 1
445 445 line 0/0/1
...(261 lines hidden)
Code: Select all
^.*speed.(300|1200|2400|4800|9600|19200|38400|57600|115200).*$