[Fixed in 2.1.0] Copy Run Start
Posted: Tue Mar 02, 2021 6:53 pm
Testing out Unimus and I have run into a very stupid problem on my end. I assume I am just goofing something up but it is frustrating me because I know I will run into issues with prompts in the future.
So extremely basic test, push the command copy run start and I get a Interaction error with the following output.
3850sw#copy run start
Destination filename [startup-config]?
TIMESTAMP: 2021-03-02 18:39:02.806
<<SSH disconnect - channel & session>>
DEVICE OUTPUT END:
I have tried adding $[enter] but that has not helped.
Also curious what the ETA is on variables in the config push product?
So extremely basic test, push the command copy run start and I get a Interaction error with the following output.
3850sw#copy run start
Destination filename [startup-config]?
TIMESTAMP: 2021-03-02 18:39:02.806
<<SSH disconnect - channel & session>>
DEVICE OUTPUT END:
I have tried adding $[enter] but that has not helped.
Also curious what the ETA is on variables in the config push product?