[Fixed in 2.1.0] NMS Sync "Successful" with 1 failure
Posted: Thu Jul 09, 2020 2:26 pm
When my NMS syncs (Zabbix) the notification in the corner of the interface shows "failed: 1 updated: 2". When I look at the Import Jobs on the dashboard, these are counted as Successful and there is no ability to view the log.
- An import job with failed items should be Failed, not Successful
- The failure is caused by assigning one of my devices to a Zone, after it was initially imported by the same NMS Sync job. If I change this device's Zone to the Core (0) then the NMS Sync succeeds, but of course the device discovery/backup fails. Changing it back to the proper zone again causes the NMS Sync to report it as a failure.
- It would be great if we could assign zones via the NMS. For Zabbix specifically I see two ways:
- Use separate groups for each zone (simple solution)
- Create a mapping between Zabbix Proxies and Zones (the harder but better solution)