Unimus forum

I'm getting recurring notifications where a large portion of contiguous configuration is being reported as "removed" then an hour later "added".
No configuration changes are occurring on the device itself and seems to be isolated to JunOS devices.

Backups and notifications were working fine until Unimus 2.0 was installed, this has occurred in 2.0.1 and 2.0.2.

Hello,

This is a rather strange issue - since jobs are completing successfully for you, but some data seem to be missing.

Can you please enable "Device Output Logging" and "Debug logging" in "Zones > Default > Debug mode"?
After enabling these, please re-run the backup job multiple times on the device which is showing the changes.

After you capture logs for a few runs showing changes, please download both log files and create a ticket on our Portal with the logs.

We will definitely investigate what is happening here, and the logs should be able to tell us what's going on.

Thanks!