I have been using Unimus to push out "copy running-config startup-config".
This has been working fine but today I have got "Push preset in Read-only mode. You need access to all devices in this preset to use it".
I get this even it I try to create a new preset which is what I was trying to do, also trying to split the existing preset up so this should not be an issue especially as the user has full access to all switches
Mass config push in Read-Only mode
Hi,
to help you with identification of possible root cause we would need some additional information.
Could you please clarify if the targets use by preset were added per address, per tag, or as a combination of both?
Additionally, you mentioned that the same issue occurs during the creation of a new preset.
Do you know in which exact point does the banner appear? Is it after adding targets or during any other specific action?
to help you with identification of possible root cause we would need some additional information.
Could you please clarify if the targets use by preset were added per address, per tag, or as a combination of both?
Additionally, you mentioned that the same issue occurs during the creation of a new preset.
Do you know in which exact point does the banner appear? Is it after adding targets or during any other specific action?
The message “Push preset in read-only mode You need access to all devices in this preset to use it” indicates that the user does not have sufficient permissions to execute the preset on the selected devices as described in our wiki: https://wiki.unimus.net/display/UNPUB/O ... s+Policies .
If permissions are correctly configured and the issue persists, further investigation is needed. Please provide the unimus.log file to help identify the problem.
If permissions are correctly configured and the issue persists, further investigation is needed. Please provide the unimus.log file to help identify the problem.