[Implemented] Unable to discover Aruba Wireless Controller
Posted: Wed Jun 20, 2018 4:32 am
I'm trying to add an Aruba 7010 wireless controller, but am getting the following in the logs:
Output recognition timeout reached while trying to talk to 'xxx.xxx.xxx.xxx'!
Discovery reports an unsupported device on 'xxx.xxx.xxx.xx'
Show version shows:
Aruba Operating System Software.
ArubaOS (MODEL: Aruba7010), Version 6.5.4.7-FIPS
Website: http://www.arubanetworks.com
(c) Copyright 2018 Hewlett Packard Enterprise Development LP.
Compiled on 2018-04-21 at 19:22:08 UTC (build 64553) by p4build
ROM: System Bootstrap, Version CPBoot 1.0.7.0-FIPS (build 56554)
Built: 2016-09-22 05:26:32
Built by: p4build@re_client_56554
Switch uptime is 29 days 19 hours 33 minutes 34 seconds
Reboot Cause: User reboot (Intent:cause:register 78:86:50:60)
Supervisor Card
Processor (XLP208 Rev B1 (Secure Boot) , 800 MHz) with 3785M bytes of memory.
32K bytes of non-volatile configuration memory.
1936M bytes of Supervisor Card system flash.
I have tried with enable mode turned on as well as enable bypass configured.
Any ideas?
Output recognition timeout reached while trying to talk to 'xxx.xxx.xxx.xxx'!
Discovery reports an unsupported device on 'xxx.xxx.xxx.xx'
Show version shows:
Aruba Operating System Software.
ArubaOS (MODEL: Aruba7010), Version 6.5.4.7-FIPS
Website: http://www.arubanetworks.com
(c) Copyright 2018 Hewlett Packard Enterprise Development LP.
Compiled on 2018-04-21 at 19:22:08 UTC (build 64553) by p4build
ROM: System Bootstrap, Version CPBoot 1.0.7.0-FIPS (build 56554)
Built: 2016-09-22 05:26:32
Built by: p4build@re_client_56554
Switch uptime is 29 days 19 hours 33 minutes 34 seconds
Reboot Cause: User reboot (Intent:cause:register 78:86:50:60)
Supervisor Card
Processor (XLP208 Rev B1 (Secure Boot) , 800 MHz) with 3785M bytes of memory.
32K bytes of non-volatile configuration memory.
1936M bytes of Supervisor Card system flash.
I have tried with enable mode turned on as well as enable bypass configured.
Any ideas?