Hi, please may you add support for Packetfront/Waystream switches. The CLI is very similar to cisco.
Regards Christian
Support for Waystream Switches
Hi,
Could you please create a support ticket in our portal and attach the debug logs from the failed discovery of the mentioned device?
Please enable both logs (Debug Log and Device Output Log) and run the discovery. After the discovery finishes (fails), you can download both logs from the Debug Mode window.
To enable general debug logging, go to Zones > Your Zone (the zone where you assigned the required device) > Debug mode, and enable Debug mode and Device output logging.
Additionally, it would be helpful to know if it is possible to execute the backup command "show running-config" on this device with a positive result.
Thank you.
Could you please create a support ticket in our portal and attach the debug logs from the failed discovery of the mentioned device?
Please enable both logs (Debug Log and Device Output Log) and run the discovery. After the discovery finishes (fails), you can download both logs from the Debug Mode window.
To enable general debug logging, go to Zones > Your Zone (the zone where you assigned the required device) > Debug mode, and enable Debug mode and Device output logging.
Additionally, it would be helpful to know if it is possible to execute the backup command "show running-config" on this device with a positive result.
Thank you.