[Implemented] Netgear ProSafe M4300

[revocloud]

We are running a stack of Netgear ProSafe M4300 switches in one of our locations. Could you add support for these?

[Tomas]

We would be happy to add support for these switches.
This however requires development from our side - we need to write a device driver that will facilitate support for these.

Is there any chance you have one of these devices in a lab where we would have SSH access to?
(for driver development)

Alternatively, we can setup a Webex session and record an SSH capture from one of these with you.
(we can then develop the driver based on the SSH capture)

If either of those is possible, please create a support ticket on our Portal, and we will work out the details from there.

[revocloud]

I had missed your reply earlier. I just sent you a support request. Thanks!

[bruor]

Sending a support request for these also. We use them for our vsphere cluster and I'd love to have the configs backed up.

[Tomas]

Update: support for Netgear ProSafe (M4300, etc.) was added in 2.0.10.

[bruor]

Thanks for this!

[pavel_tesar]

Hello, Tomas

Can I ask you, if was included also: NETGEAR M4350-24F4V 24x10G SFP+ 4x25G SFP28 Managed Switch?
Because seems, that thsi one is successor of M4300... Base on log on switch, I can login, but I cannot Discover it...

In Unimus log file is:
2024-06-04 08:45:38.868 INFO 5508 --- [discovery-313] n.u.c.s.d.p.info.ResultManipulator : Discovery reports an unsupported device on '10.82.16.1'

if it was not included, is it possible add it? It's almost the same as M4300 series just have 4x25Gbps ports.